How Do You Find The Thermal Fuse On A Maytag Dryer?

This fuse is located on the exhaust duct. If the dryer overheats, the thermal fuse opens to cut off power to the dryer. The thermal fuse cannot be reset–if the thermal fuse is open, it must be replaced.

does maytag dryer have a fuse?

Shop Maytag Dryer Fuse, Thermal Fuse & Breaker Parts. Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. If the dryer does not heat the most common cause is a blown thermal fuse.

how do I reset my thermal fuse? How to Reset a Thermal Fuse

how do I know if my thermal fuse is blown?

Touch the left multimeter lead to the left side of the thermal fuse; touch the right multimeter lead to the right side of the fuse. Keep an eye on the multimeter needle; a needle that fails to move indicates a blown thermal fuse. If this is the case, don’t fret: thermal fuse replacement is a simple task.

Does my Maytag dryer have a reset button?

There is not a reset button on this dryer. If the dryer won’t start, I recommend checking the breakers to see if they are tripped. If the breakers are okay, you could have a defective door switch, a timer problem or a wiring failure that is preventing your dryer from starting.

Where is the thermal fuse located?

Thermal fuses are installed on the dryer’s exhaust duct. Typically, you must remove the back panel of a dryer to access the fuse. Ensure to shut off electrical power to the dryer before attempting to locate and troubleshoot the fuse.

Does a Maytag Centennial dryer have a reset button?

One thing that Maytag dryers do not have, however, is a reset button. It is possible to reset the dryer through a few steps.

How do you reset a Maytag?

Unplug the washer for 1 minute from the electrical outlet. Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid. The motor has now been reset and is ready for you to start a cycle.

How do you diagnose a dryer problem?

Problem: Dryer Won’t Start The door latch may not be engaging. Check the latch for lint and clean it completely so that the door closes properly. Check the power supply, including fuses and circuit breakers. Check the dryer’s internal thermal fuse. If you have a push start knob, it may not be engaging correctly.

Why is my Maytag dryer not starting?

On most dryers the drive motor turns the drum and the blower wheel to exhaust the air. If the dryer won’t start the motor might be defective. Before replacing the motor, check the thermal fuse, start switch and door switch because all three are more likely the cause. The dryer motor can’t be tested easily.

Are all dryer thermal fuses the same?

All dryers sold in the United States are legally required to have a thermal fuse. This is different from the electrical fuses that are found in many appliances, and a dryer might have both. A thermal fuse will blow when the temperature gets too high, not when it’s drawing too much current.

How do you bypass the thermal fuse on a Maytag dryer?

Locate and Bypass the Fuse The thermal fuse will look like a thin strip of white plastic with a wire coming out of each end. In order to bypass the thermal fuse, use electrical tape to tape the two ends together. The thermal fuse will then be bypassed. Turn the dryer on to a heat cycle for no more than 90 seconds.

How do you test a thermal fuse?

How to Check a Dryer Thermal Fuse Unplug the dryer and remove the front access panel. Locate the blower cover–it’s the large object facing you at the bottom of the dryer. Remove the wires from the thermal fuse terminals to test it. Set your multimeter to the R x 1 scale and touch the leads to the thermal fuse terminals to test for continuity.

Where is the thermostat on a Maytag dryer?

The cycling thermostat is attached to the dryer’s duct housing, which is located near the bottom of the appliance. Once you find the component, disconnect the wires running to the thermostat terminals. With the wires detached, unthread the mounting screw that secures the thermostat to the duct housing.

What does a thermal fuse do?

A thermal fuse is a cutoff which uses a one-time fusible link. Unlike electrical fuses or circuit breakers, thermal fuses only react to excessive temperature and not to excessive current (unless the excessive current is sufficient to cause the thermal fuse itself to heat up to the trigger temperature).

Watch full movie for free, click here daily update 👉 https://justwatch.cc